Husqvarna T525 - Troubleshooting and Transportation; Engine Starts But Stops Again; Transportation and Storage

28 – English
7.8 Assembling the ignition module and
the ywheel
1
Fit the ywheel onto the crankshaft journal. Turn
the ywheel until the key ts into the key slot on the
axle. See gure 18.
The ignition module must be tted as follows:
2
Pull the ignition module cabling through the
crankcase and place the ignition module in
position. See Figure 19.
3
Turn the ywheel so that the magnets are aligned
with the ignition module and place the plastic feeler
gauge, 514 24 41-01, between the lugs on the
ignition module and the ywheel magnets. See
Figure 20.
4
Tighten the screws for the ignition module and
remove the plastic feeler gauge.
5
Fit the spark plug cap on the ignition cable.
Note! When tting a new ignition module a hole
has to be made in the ignition cable for the spring.
Use the assembly pliers, 502 50 06-01. See Figure
21.
6
Pull the ignition cable through the tank unit to the
spark plug.
7
Attach the:
• Starter unit
• Stop switch
• Spark plug
• Spark plug cable
• Cylinder cover
Fig 19
Fig 18
Fig 21
Repair instructions
Fig 20
0,4 mm.