Husqvarna T525 - Safety Device Checks; Check Brake Band; Check Front Hand Guard; Check Chain Brake

18 – English
Safety equipment
6.5B Replacing the chain catcher
A worn chain catcher must always be replaced with
a new one.
1
Release the brake by moving the kickback guard
backwards. Loosen the bar nut and remove the
clutch cover, saw chain and bar.
2
Loosen the screw and replace the chain catcher
with a new one as shown in Figure 12b. Tightening
torque 2.5 - 3.9 Nm.
Fig 12b
Fig 12a
6.5A Assembling the spike bumper
(accessories)
The spike bumper is not tted at the time of deliv-
ery.
1
Release the brake by moving the kickback guard
backwards. Loosen the bar nut and remove the
clutch cover, saw chain and bar.
2
Fit the spike bumper as outlined in Figure 12a.
Then t the saw chain, the bar and the clutch
cover.