Husqvarna T525 - Replacing the Fuel Hose; Vibration Damping System

English – 45
Repair instructions
7.23 Vibration damping system
The vibration damping system consists of three
antivibration element. See Figure 59.
Dismantling the dampers
Make sure to dismantle the dampers in the order
that follows.
Fig 59
Fig 58
7.22 Replacing the fuel hose
1
Remove the air lter cover, air lter and carburetor.
Remove the fuel lter as outlined in Figure 55.
2
Carfully pry open the engine case cover with a at
screwdriver. See Figure 57.
3
Remove the two parts of the fuel hose as outlined
in Figure 58.
4
When assembling, make sure that the fuel hose is
tted into the groove as outlined in Figure 58.
Fig 57
NOTE!
Fluted pliers may not be used with the fuel
hose. They can cause material damage
resulting in damage to the fuel hose.