Husqvarna T525 - Page 46

46 – English
Dismantling rear damper
1. Remove the air lter cover, cylinder cover
2. Remove the screw (A).
3. Remove the bolt (B).
4. Remove the antivibration element (C).
Dismantling bottom damper
1. Remove the two screws holding the grip cover.
Remove the grip holder. See Figure 61.
2. Remove the screw holding the front handle.
See Figure 61.
3. Remove the screw and the front handle. Re-
move the antivibration element. See Figure 62.
B
A
C
Fig 60
Fig 61
Fig 62
Repair instructions