Husqvarna T525 - Dismantling the Intake System

English – 39
7.14 Dismantling the intake system
1. Remove the air lter cover, cylinder cover.
2. Remove the screw (A).
3. Remove the bolt (B).
4. Remove the antivibration element (C).
5. Remove the two screws holding the grip cover.
Remove the grip holder. See Figure 48.
6. Remove the screw and the front handle. Re-
move the antivibration element. See Figure 49.
7. Remove the throttle components.
8. Remove the air lter
9. Remove the carburetor.
10. Remove the engine case cover.
Fig 47
Fig 48
Fig 49
Repair instructions
B
A
C