Husqvarna T525 - Page 38

38 – English
Repair instructions
Assemble on the saw
1
Hook the link rod (D) to the carburetor as outlined
in Figure 45. Attach the two inlet manifolds to their
corresponding grommet. Slide the purge (B) into
place. Attach the suction hose (A) as outlined in
Figure 45. Make sure to attach the fuel hose (E) to
the carburettor guide correctly as outlined in Figure
45..
2
Attach the air lter. See Figure 46. Attach the air
lter cover.
Fig 45
Fig 46
A
B
D
C
E
E