Huvitz CDR-9000 - Page 211

210 Digital Refractor CDR-9000
IEC 61000-4-11
For 5 cycle
70% U
T
(30% dip in U
T
)
For 25 cycle
<5% U
T
(>95% dip in U
T
)
For 5 cycle
40% U
T
(60% dip in
U
T
)
For 5 cycle
70% U
T
(30% dip in
U
T
)
For 25 cycl
e
<5% U
T
(>95% dip
in U
T
)
For 5 cycle
mmended that the CDR-9000 be po
wered from an uninterruptible power
supply or a battery.
Power frequency (5
0/60Hz) magnetic fi
eld
IEC 61000-4-8
3A/m
3A/m
Power frequency magnetic fields sho
uld be at levels characteristic of a ty
pical location in a typical commercial
or hospital environment
Note: U
T
is the a.c. mains voltage prior to application of the test level.
Table 3: Guidance and manufacturer’s declaration – electromagnetic immunity
The CDR-9000 is intended for use in the electromagnetic environment specified below. The custo
mer or the user of the CDR-9000 should assure that it is used in such an environment.
Immunity test
IEC 60601 test level
Compliance
level
Electromagnetic environment-guidance
Conducted RF I
EC 61000-4-6
Radiated RF
IEC 61000-4-3
3 Vrms
150 kHz to 80MHz
3 Vrms
80MHz to 2.5GHz
3V
3V/m
Portable and mobile RF communications
equipment should be used no closer t
o any part of the SYSTEM, including ca
bles, than the recommended separation
distance calculated from the equation a
pplicable to the frequency of the transm
itter.
Recommended separation distance
P
V
d ]
5.3
[
1

P
E
d ]
5.3
[
1

80MHz to 800MHz
P
E
d ]
7
[
1

800MHz to 2.5GHz