Pg 1.7 S23P 2001e
POWER WIRING CONNECTIONS
When the machine has been anchored and levelled the power hook-up is the last installation step. In order to
provide safe operation and to prevent potential damage to the machine, only qualified personnel should make the
electrical connections. If the hydraulics do not register an immediate pressure rise,
- SHUT THE HYDRAULICS OFF -
and change the phase order. As supplied your new S-23P is set to run on three phase voltage. The supply
voltage of the machine is shown on the serial plate attached to the front of the machine. Connection from the Main
supply is made to L1, L2, L3, and ground terminals in the electrical control box as shown below.
Supply conductors should be rated for the current supplied and should be protected by time delay fusing rated
for the amperage stated on the machine serial plate.
CHECK FOR: -Signs of damage to the electrical cables from shipping or installation.
-Correct phase order - The blade should be running counterclockwise.
( If the blade direction is wrong, any two lines should be reversed to correct)
SPEED ADJUSTOR INSTALLATION
The speed adjustor is packaged seperately for shipping purposes and must be installed prior to connecting the
power supply. Failure to do so will cause a safety hazard. Refer to page 6.44 for installation instructions.
L1
L2
L3
GROUND
Main power connections found
inside the control box.
The power cable should be routed
through the two holes found at the
left end of the control box beside
the motor power cable. A suitable
strain relief should be used.
To Next Page
Loading...
Need help?
General
