2.3
MANUAL OPERATION CONTROLS
TOP ROW
HEAD CONTROL:
RETRACT: The head will retract until it reaches the HEAD BACK LIMIT SETTING.
HOLD: The head will remain stationary.
ADVANCE: The head will advance until it reaches the HEAD ADVANCE LIMIT SETTING
determined by the vise opening. Advance is controlled by the FEED RATE and FEED FORCE
controls.
HYDRAULIC START:
Starts hydraulic pump motor and energizes the BLADE START BUTTON. This button is illumi-
nated when ON to give the operator an indication that the hydraulic system is running. The head
selector switch as well as the both vise selector switches have to be in their neutral centre posi-
tion for hydraulics to start.
LEFT VISE:
This switch operates the vise on the left side of the blade. If the switch is placed in the neutral
(centre) position, the vise jaw will hold it’s position. For the blade to start at least one of the
vises has to be in the closed position, and the other must be in the closed or open position (not
neutral).
BLADE START:
This button is only active when the hydraulic system is running. Momentarily depressing this
button will start the blade motor. This button is illuminated for operator safety while the blade
is running. This button can not start the blade running unless both vises are closed, or one
closed and the other open.
CHIP CONVEYOR:
This OPTIONAL switch controls the direction of the chip conveyor to dump the chips to the left
or right side of the machine.
MIST:
This OPTIONAL switch has three positions - AUTO, OFF and ON.
OFF: No mist coolant.
AUTO: The mist coolant sprays only when the Head is advancing into the cut.
ON: Mist coolant sprays any time the machine is under power.
To Next Page
Loading...
