Hypertherm Powermax 125 Field Service Bulletin

Torch Alignment Guide for Bevel Cutting
Powermax125 / MAXPRO200 Field Service Bulletin 811280 11
Bevel compensation cut charts
The following bevel compensation cut charts are given in metric and English units:
 Powermax125 – Mild steel – Air
 MAXPRO200 – Mild steel – 200 A – O
2
Plasma / Air Shield
 MAXPRO200 – Mild steel – 200 A – Air Plasma / Air Shield
 MAXPRO200 – Mild steel – 130 A – O
2
Plasma / Air Shield
 MAXPRO200 – Mild steel – 130 A – Air Plasma / Air Shield
All of the cut chart processes in
this document are for
single-pass, V cuts .
7
7

Hypertherm Powermax 125 Specifications

General

Output Current	30-125 A
Input Power	15.2 kW
Open Circuit Voltage	300 VDC
Gas Supply	Clean, dry, oil-free air or nitrogen
Input Power Cable Length	10 ft (3 m)
Rated Output Current	125 A
Gas Type	Air or nitrogen
Cutting Capacity	1-1/4 inch (32 mm)
Pierce Capacity	1 inch (25 mm)
Input Voltage	200-600 V, 3-PH
Duty Cycle	100% @ 125 A
Certifications	CSA
Maximum Clean Cut Thickness	1-1/4 inch (32 mm)
Cooling Method	Fan-cooled
Torch Options	Hand