Hypertherm powermax1250 User Manual

OPERATION
0
powermax1250 Operator Manual 4-13
WARNING
SPARKS AND HOT METAL CAN INJURE
EYES AND BURN SKIN
When firing the torch at an angle, sparks and hot metal will
spray out from the nozzle. Point the torch away from yourself
and others.
Piercing
Hold the torch so that the nozzle is within 1/8 inch (3 mm) from the workpiece before firing the
torch.
Fire the torch at an angle to the
workpiece, then slowly rotate it to an
upright position.
When sparks are exiting from the
bottom of the workpiece, the arc has
pierced through the material.
When the pierce is complete,
proceed with the cut.

Hypertherm powermax1250 Specifications

General

Brand	Hypertherm
Model	powermax1250
Category	Welding System
Language	English