Hytera PD68X User Manual

Receiving an All Call
When you receive an all call, the radio displays
, and the call is
established automatically.
Ending an All Call
In conventional mode, an all call ends when the Time-out Timer (TOT)
expires.
In trunking mode, an all call ends in any of the following cases:
l The calling party ends the call.
l The call duration exceeds the period preset by your dealer.
l A preemptive or emergency call interrupts the call.
l The base station signal is lost.
Broadcast Call (Trunking Only)
A broadcast call is a special group call to which the called party cannot
respond. The radio must be authorized by your dealer for you to initiate a
broadcast call.
Initiating a Broadcast Call
The following table describes how to initiate a broadcast call.
Manner Operation
Favorites
1. Go to Menu > Contact > Favorites.
2. Select the target group contact, and then press the
OK/Menu key.
3. Select Call Type, and then select Broadcast Call.
4. Press
or press and hold the PTT key to initiate the
call.
Subgroup
1. Press the preprogrammed Subgroup key or go to
Menu > Subgroup.
2. Select the required subgroup, and then select
Member.
3. Select the target group contact, and then press the
OK/Menu key.
4. Select Call Type, and then select Broadcast Call.
5. Press
or press and hold the PTT key to initiate the
call.
Manual Dial
1. Go to Menu > Settings > Radio Set > Keypad
Mode, and then select Enable.
2. From the home screen, enter the broadcast call
number using the keypad.
3. Press or or press and hold the PTT key to
initiate the call.
Call Log
1. Go to Menu > Call Logs >
Outgoing/Incoming/Missed > Outgoing List /
20

Hytera PD68X Specifications

General

Brand	Hytera
Model	PD68X
Category	Portable Radio
Language	English