VOX
The VOX feature allows you to transmit voice without pressing and holding
the PTT key. The radio automatically transmits voice when the volume
reaches the preset level.
To turn on or off this feature, go to Menu > Settings > Radio Set > VOX >
On/Off, and then select On or Off. When this feature is enabled, the radio
displays .
To set the sensitivity of the external or internal microphone, go to Menu >
Settings > Radio Set > VOX > Gain Level > External/Internal, and then
select the appropriate level. A higher gain level indicates lower sensitivity,
which requires higher volume for triggering transmission.
Call Divert
The Call Divert feature allows you to divert an incoming half-duplex private
call to a designated radio.
To turn on this feature, do as follows:
1. Go to Menu > Settings > Radio Set > Call Divert > On/Off, and then
select On.
2. Select Divert ID, and enter the ID using the keypad.
3. Press the OK/Menu key.
To turn off this feature, select Off under Call Divert.
Call Priority
The Call Priority feature allows you to set the priority of voice services
except emergency call. When all channels are occupied, the call requests
are put in a queue according to their priorities. During queuing, the radio
displays "Call Queued".
To set the priority, go to Menu > Settings > Radio Set > Priority, and then
select one of the following as required: Low, Medium, High, and
Preemption.
The Preemption option is available only when the Preemptive Call feature
is enabled by your dealer. A preemptive call does not need to queue.
DGNA
The DGNA feature allows you to join a dynamic group added by the
authorized dispatcher over the air interface according to temporary task
requirements. The dispatcher can also delete the dynamic group from your
radio.
The radio displays "DGNA Success!" when the dynamic group is added
successfully and "DGNA Deleted" when the dynamic group is deleted. The
added dynamic group is saved in a dynamic subgroup list under Subgroup on
your radio.
32
To Next Page
Loading...
Need help?
General
