Hytorc BTM-0250-DOC - 5 Charge, Test & Install Battery; Charge the Battery; Charging Indicator

LITHIUM SERIES® Electric Torque Tool (BTM-DOC Models) Operations Manual
13
. CHARGE, TEST & INSTALL BATTERY
CHARGE THE BATTERY CHARGING INDICATOR
• The LITHIUM SERIES Tool is supplied with two long life
36 volt batteries and a charger.
• Before charging a battery verify the local voltage supply
to ensure capability with the charger; this will typically
be 110 Volts or 220 Volts AC.
• Connect the charging cradle to the power supply.
• Connect the power cord to a grounded outlet.
• If necessary connect the plug adapters for the local
power outlet.
• Insert the battery by sliding it into the charger and
locking into place. The power indicator will be
illuminated green when plugged in.
• The charging indicator flashes green while charging and
turns solid green when the battery is fully charged.
• The 36 volt battery is fully charged in approximately 90
minutes.
1. Charging Cable
2. Battery Pack
3. Charging Cradle
4. Power Supply
5. Power Supply Cord
6. Power Indicator
7. Legend
8. Charging Indicator
9. Fault Indicator
• POWER INDICATOR green when charger is plugged into
AC outlet.
• CHARGING INDICATOR is flashing green while battery
is charging.
• CHARGING INDICATOR solid green when battery is fully
charged.
• FAULT INDICATOR is flashing red for battery fault not
charging.
• Battery is charged in approximately 90 minutes.
1
2
4 5
6
7
8 9
3