Hytorc BTM-0250-DOC - 10 Bolting with the Hytorc Washer; Install Hytorc Washer Driver

32
INSTALL THE HYTORC WASHER DRIVER
• The LITHIUM SERIES Tool is easily configured for
tightening bolts where the HYTORC Washer is used.
• Identify the appropriate size HYTORC Washer Driver.
• Slide the washer driver over the square drive and spline
while aligning the thumb screw with the flat on the spline.
• Tighten the thumb screw to secure the Driver.
• Challenge the driver to make sure it is securely attached.
. BOLTING WITH THE HYTORC WASHER