24
SYSTEM MENU
The SYSTEM menu contains additional settings for tool configuration.
• The green bar highlights the current position
• Press left button f to scroll down, right button to scroll up
• Press the center button i to select and display a sub-menu
NOTE: The SET UP DEVICE and DIAGNOSTIC Menu items are not intended for field use.
These functions are password protected and only accessible by HYTORC in the factory.
Displays Firmware (FW) and Hardware
(HW) versions for MDC (Motor Drive
Control) And UIC (User Interface
Control).
Press any button to return to SYSTEM
menu.
Provides capability to orient the display
in normal or inverted mode:
NORMAL Screen is legible when
battery is down.
INVERT Screen is legible when battery
is up.
INVERT FOR CAL Inverted for
calibration
Scroll down i or scroll up to reach
desired orientation for the display and
push to select the orientation and
return to the SYSTEM SETTINGS menu.
The user can optionally enable or
disable the beeper.
Press buttons to scroll i or to
highlight the desired state for the
beeper, press to select beep OFF or
ON and return to the ADMIN menu.
If turned on, the beeper will sound one
time for each successful operation and
4 times to indicate an error.
To Next Page
Loading...
