LITHIUM SERIES® Electric Torque Tool (BTM-DOC Models) Operations Manual
19
OPERATION MENU
The Operation menu contains most functions for everyday operation.
• The green bar highlights the current position
• Press left button f to scroll down, right button to scroll up
• Press the center button i to select and display a sub-menu
(Continued on following page)
In order to save or load a job profile the
user must first enter the 4-digit code to
unlock the tool. To enter the code press
button to increase the digit or i to
decrease the digit, press to advance
to the next digit until the correct code
is entered (default 0000). When the
4-digit code is entered correctly press
again to JOB PROFILES.
NOTE: Wrong code returns user to
previous screen. There is no limit on
number of attempts. See administrator
for correct code.
Allows the user to save tool parameters
to memory as a Saved Job Profile (SJP),
or to load previously saved parameters
(SJPs) from memory.
The tool can save up to 8 job profiles;
each profile includes saved values for
TORQUE (T), ANGLE (A), RELEASE (R)
and fastener type. Scroll and select the
desired setup values – then select ,
or if saving new setup values select
to access submenu to either SAVE or
LOAD settings.
The user can SAVE the settings
currently on the home display – now
shown in SAVE settings - by pushing
the left button i also adds the profile to
the top of JOB PROFILES.
Alternatively, the user can LOAD the
selected profile – now shown in LOAD
settings - by pushing the right button
. Exit without load or save by hitting
the center button X. Return to the
OPERATION Menu upon completion.
To Next Page
Loading...
