20
Press appropriate button i to scroll
up or down, push to select fastener
type:
RH RIGHT HAND bolts tightened
clockwise.
LH LEFT HAND bolts tightened
counterclockwise.
HN HYTORC NUT tightened
counterclockwise.
HW HYTORC WASHER tightened
clockwise.
Any selection returns users to
OPERATION menu.
NOTE: When using the HYTORC
Washer or HYTORC Nut the safety
feature requiring a push of the button
before operation is disabled. Tool
should never be used with a reaction
arm in this setting.
Allows the operator to select the
preferred units of the torque display.
Press buttons to scroll i or to
highlight the desired units, press to
select desired units and return to the
OPERATION menu.
The user can adjust the time delay for
applying the ANGLE and RELEASE
following the TORQUE operation – the
delay can range from 0ms to 3000ms.
The time delay is applied after the
TORQUE value by continuing to hold
the trigger.
Push up button to increase the delay
or down button i to decrease the delay.
Select to return to the OPERATION
menu.
(OPERATION MENU continued from previous page)
To Next Page
Loading...
