LITHIUM SERIES® Electric Torque Tool (BTM-DOC Models) Operations Manual
33
TIGHTENING WITH THE HYTORC WASHER DRIVER
• Power on the tool, adjust tool settings and set the
fastener type to HYTORC WASHER.
• If necessary set the speed switch to RUN DOWN to
quickly run down the nuts until they are flush against the
flange. Set the speed switch back to Torque after the
run down is complete.
• Position the tool over the nut and HYTORC Reaction
Washer.
• Pull the trigger to apply torque until the tool reaches the
desired torque and stops.
• If an ANGLE has been specified, continue holding the
trigger, the tool will pause and restart after the angle
delay.
• If a RELEASE has been specified, continue holding the
trigger, the tool will pause and restart after the angle
delay.
• Release the trigger after the tool has completed all
specified operations.
• During the operation the status light turn amber during
operation. If the operation is successful the status light
will turn green, if unsuccessful the status light will turn
red
• If the BEEPER is enabled the tool will provide an audible
beep upon completion of the operations.
• Remove the tool socket from the nut.
• Should torque be applied without a release angle the
tool may lock onto the nut. If this happens set the tool to
loosen to free the tool and repeat the tighten operation.
To Next Page
Loading...
