30
CONVENTIONAL TORQUE TIGHTENING
• To begin the TORQUE operation, pull and hold the trigger.
• With Right or Left Fasteners, a message is displayed instructing the user press an additional button on the control panel
to ensure the operator keeps both hands clear of the reaction arm.
• As soon as the user pushes the drive will turn.
• Once the tool starts the reaction arm will move to firmly press against the reaction surface and then the tool will begin
applying torque and tighten the nut.
• Continue holding the trigger until the tool reaches the desired torque and stops.
• If an ANGLE has been specified, continue holding the trigger, the tool will pause and restart after the angle delay.
• If a RELEASE has been specified, continue holding the trigger, the tool will pause and restart after the angle delay.
• Release the trigger after the tool has completed all specified operations.
• The status light turn amber during operation. If the operation is successful, the status light will turn green,
if unsuccessful the status light will turn red.
• If the BEEPER is enabled the tool will provide an audible beep upon completion of the operations.
• Remove the tool socket from the nut.
• Should torque be applied without a release angle the tool may lock onto the nut. If this happens set the tool to loosen to
free the tool and repeat the tighten operation.
To Next Page
Loading...
