Hytorc BTM-0250-DOC - Page 9

LITHIUM SERIES® Electric Torque Tool (BTM-DOC Models) Operations Manual
9
IMPORTANT BATTERY CHARGER SAFETY INSTRUCTIONS
• Before using charger, read all instructions and
cautionary markings on charger, battery pack and
product using battery pack.
• Do not attempt to charge the battery pack with any
chargers other than the one in this manual. The
charger and battery pack are specifically designed to
work together.
• These chargers are not intended for any uses other
than batteries supplied with LITHIUM SERIES Tools
as described in this manual. Any other uses may result
in risk of fire, electric shock or electrocution.
• Do not expose charger to rain or snow.
• To disconnect charger, firmly grasp plug and remove.
Do not disconnect the charger by pull-ing on the cord.
• Make sure the cord is located so that it will not be
stepped on, tripped over, or otherwise subjected to
damage or stress.
• Do not use an extension cord unless it is absolutely
necessary.
• An extension cord must have adequate wire size
(AWG) for safety. In general the larger the wire size the
greater the capacity of the cable.
• Do not block any ventilation slots on charger power
supply.
• DO NOT attempt to charge the battery pack with
any chargers other than the one in this manual. The
charger and battery pack are specifically designed to
work together.
• These chargers are not intended for any uses other
than batteries supplied with LITHIUM SERIES Tools
as described in this manual. Any other uses may result
in risk of fire, electric shock or electrocution.
• Do not expose charger to rain or snow.
• To disconnect charger, firmly grasp plug and remove.
Do not disconnect the charger by pull-ing on the cord.
• Make sure the cord is located so that it will not be
stepped on, tripped over, or otherwise subjected to
damage or stress.
• Do not use an extension cord unless it is absolutely
necessary.
• An extension cord must have adequate wire size
(AWG) for safety. In general the larger the wire size the
greater the capacity of the cable.
• Do not block any ventilation slots on charger power
supply.
WARNING!
WARNING!
CAUTION!
Burn hazard. Battery liquid may be flammable if exposed to spark or flame.
Burn hazard. To reduce the risk of injury, charge only tool batteries. Other types of batteries may burst
causing personal injury and damage.
Under certain conditions, with the charger plugged into the power supply, the charger can be
shorted by foreign material. Foreign materials of a conductive nature such as, but not limited to, steel
wool, aluminum foil, or any buildup of metallic particles should be kept away from charger cavities.
Always unplug the charger from the power supply when there is no battery pack in the cavity. Unplug
charger before attempting to clean.