Hytorc LITHIUM II Series - Bolting with HYTORC Nut; Install HYTORC Nut Driver

23
INSTALLING THE HYTORC NUT DRIVER
• The LITHIUM SERIES® II Tool is easily conigured or tightening the HYTORC Nut
• Identiy the appropriate size HYTORC Nut Driver
• Slide the nut driver over the square drive and spline while aligning the set screw with the lat on the spline
• Pin the driver to the square drive to secure the driver to the tool
• Tighten the set screw to secure nut driver
• Challenge the nut driver to make sure it is securely attached
15. BO LTIN G WITH T HE HY TORC NUT