Hytorc LITHIUM II Series - Tightening the HYTORC Nut

LITHIUM SERIES® II Electric Torque Tool Operations Manual
24
NOTE: The HYTORC Nut inner sleeve is tightened in the counter clockwise direction (let hand threads).
• Power on the tool, select the desired torque using the up and down arrow buttons and set the astener type to
HYTORC Nut
• Position the tool over the nut
• Pull the trigger to apply torque until the tool stalls at the speciied torque
• I a RELEASE ANGLE has been speciied continue holding the trigger and the tool will restart and then stall again
ater completing the RELEASE angle. Then the tool can be released rom the nut.
• Release the trigger ater the tool has completed all speciied operations
• The status light will turn amber during operation. I the operation is successul, the status light will turn green, i
unsuccessul the status light will turn red.
• I the BEEPER is enabled the tool will provide an audible beep upon completion o the operations
• Remove the tool driver rom the nut
• Should torque be applied without a release angle the tool may lock onto the nut. I this happens set the tool to
loosen to ree the tool and repeat the tighten operation.
TIGHTENING THE HYTORC NUT
(CO NT ’ D .)