1
Notices
References in this publication to IBM products, programs, or
services do not imply that IBM intends to make these
available in all countries in which IBM operates. Any
reference to an IBM product, program, or service is not
intended to state or imply that only IBM’s product, program, or
service may be used. Any functionally equivalent product,
program, or service that does not infringe any of IBM’s
intellectual property rights, or other legally protectable rights,
may be used instead of the IBM product, program, or service.
References in this publication to IBM products, programs, or
services are purely hardware-related and do not cover
circumstances of software problems. Evaluation and
verification of operation in conjunction with other products,
program, or services, except those expressly designated by
IBM, are the user’s responsibility. IBM may have patents or
pending patent applications covering subject matter in this
document. The featuring of these patents, pending or
otherwise, in this document does not give you any license to
these patents. You can send license inquires, in writing, to
the IBM director of Commercial Relations, IBM Corporation,
Purchase, NY10577.
Voltage Supply Switch Settings
Your IBM Personal Computer
might
have voltage switches,
which must be set correctly for your voltage supply. If your
monitor or system unit has a voltage switch, complete these
steps to make sure each switch is set correctly:
1. Determine the correct voltage switch setting for your area:
Voltage Supply Range Voltage Switch
Setting
100-127 V 110 V
200-240 V 220 V
2. Locate the voltage switch on the back of your monitor or
system unit. If the setting shown on the switch is:
q
Correct: start setting up your IBM personal computer.
q
Incorrect: change the voltage switch setting.
To Next Page
Loading...
Need help?
General