129
Parts/Test Point Locations
Parts/Test Point Locations........................................... 129
Introduction..................................................................... 130
Layout of the System Board of Machine Types 2197 and
6344............................................................................... 131
Jumper Settings........................................................ 132
Connectors and Functions........................................ 133
Layout of the System Board of Machine Types 2193
and 2196........................................................................ 134
Jumper Settings........................................................ 135
Connectors and Functions........................................ 136
Power Supply Cable Connector Specifications................ 137
Main Output Pin Assignment..................................... 138
Factory-Installed Modem Card Layout............................. 140
Factory-Installed Modem Card Connector Functions. 140
3.5-In. Hard Disk Drive Jumper Locations & Settings ...... 141
CD-ROM Drive................................................................ 142
Rear Panel Connectors and Features…………………143
CD-ROM Drive Jumper Settings ..................................... 143
DIMM Configurations ...................................................... 144
System Board Connector Pin Signals..............................144
Monitor Port Signals .................................................144
Serial Port Signals .................................................... 144
Parallel Port Signals ................................................. 145
Mouse Port Signals................................................... 145
Keyboard Port Signals .............................................. 145
Diskette Drive Cable Connector Signals ................... 146
IDE Cable Connector Signals ................................... 147
To Next Page
Loading...
Need help?
General