127
Power Supply
This system has a 95-watt switching power supply.
1. To remove the power supply. You must remove the
top cover first.
2. Disconnect the power cable from the riser board and
all drives.
3. Remove the screws in the machine rear that secure
the power supply.
Memory (DIMM)
This system has 2 system memory module sockets, DIMM 0
and DIMM 1. These sockets hold dual in line memory
modules (DIMM) that contains 3.3V signal or double-sided
synchronous DRAM (SDRAM).
The maximum memory size is 512 MB total.
To Next Page
Loading...
Need help?
General