60
NOTES:
If an error message and incorrect audio response occur,
diagnose the error message first.
If you cannot run the diagnostics program tests but did
receive a POST error code, diagnose the POST error
message.
If you did not receive any error message, look for a
description of your error symptoms in “Error Symptoms List”
in page 67.
Check all power supply voltages, switch, and jumper settings
before you replace the system board. Also check the power
supply voltages if you have a “system no-power” condition.
(“Power Supply Cable Connector Specifications” on page 137
and “Layout of the System Board of Machine Types 2197 and
6344” on page 131.)
If you are unable to correct the problem by using the “BIOS
Error Codes, Messages, And Beeps List” table and “Error
Symptoms List” table, go to "Undetermined Problems” on
page 93.
To Next Page
Loading...
Need help?
General