68
Table 2-3 Error Symptoms List
Error Symptoms Action/FRU
NOTE: To diagnose a problem, first find the error symptom
in the left column. If directed to a check procedure, replace the
FRU indicated in the check procedure. If no check procedure
is indicated, the first Action/FRU listed in right column is the
most likely cause.
System Board and Memory
System works but fails
to enter power
saving mode when
the “Power
Management” is set
to [Enabled], and
power saving timer
set in BIOS has
elapsed.
Load default settings.
In Win98, check settings in Control
Panel Power utility.
Reload software from Recovery CD.
System hangs before
system boot.
“Index of Symptoms, Messages, Error
Codes, or Beeps” on page 59.
“Undetermined Problems” on page 93.
System hangs after
system boot.
Execute a system test (“Diagnostics/All
Tests” in PC-Doctor diagnostics
program) and set it to stop at “Halt on
Error” to see the potential cause of the
problem.
“Undetermined Problems” on page 93.
Blinking cursor only;
system does not
work.
“Start” on page 55.
Diskette/IDE drive connection/cables
Diskette/IDE disk drives
“Undetermined Problems” on page 93.
System board
To Next Page
Loading...
Need help?
General