IBM 3278 Series

~
!::.l
~
~
...
~
~
!::.l
For example:
03/1
0400 0000
0000 0002 0000
The last error detected by the display was error code 204. This was a storage error (buffer parity error).
Two of these errors have been detected since the
display was powered on.
3274
Display Error Log Codes
These errors appear on the screen as )(~ 2xx, where xx is one of the 2-digit numbers listed below.
02 "Hot tube", Normally, error code 11 I nvalid Status received
is seen in log of another terminal. 12 I nvalid Scan Code received
03
Feature bus error 22 I nvalid Selector Pen Status or
04*
Storage error Command Q failure
Unsupported feature attached 23 ECS buffer parity
I ncorrect feature address 24 Invalid MSR Status or Command Q failure
05
06
Lost Op Complete this display 25 ECS Status/lnitialization error
Invalid Op Complete (received 26 ECS Command Q failure
07*
08
unexpected Op Complete) 27 ECS WRT AL T/Command Q failure
09*
Command Q failure 34 ECS without ROS extension
10 I nvalid keyboard attached (no table)
*""1"'\"1-1",.,,1 IIni ... rn~v Inn nff rI",/irp
w
W
N
W
!
~
m
~
r-
.8
C
Ill'
'a
~