Removing the slanted I/O trays
The slanted I/O tray installs on the top of the system unit and groups the IBM
printer and keyboard with specific dimensions. The tray has a raised edge that is
low in the front. The sides slope up toward the rear and are higher at the rear than
at the front.
The top of the system unit serves as a built-in flat I/O tray. Use this surface when
grouping IBM and non-IBM peripheral devices with varying dimensions.
Note: A version of the slanted I/O tray is available that can be placed on the
wide-footprint SurePOS 700 in an integrated environment. Other versions of
the tray can be placed directly on the counter or on the full-size cash drawer.
The cash drawers provide a built-in flat I/O tray.
To remove a slanted I/O tray, follow these instructions:
1. Working from above the system unit, remove the screws from the holes (A in
Figure 16) inside of each corner of the I/O tray.
2. Lift off the I/O tray.
3. To remove the front mount clips, push each of the front mounting tabs forward
until it unlatches.
4. To replace the I/O tray, install the clips, place it on top of the system and install
the screws.
A
A
Figure 16. Removing the slanted I/O tray
Updated July 14, 2008
28 SurePOS 700 Series: SurePOS 700-721/741/781, 722/742/782 Hardware Service Guide
To Next Page
Loading...
