Removing the CD-ROM
Follow these steps to remove the CD-ROM:
Models with the front-service housing option
For models with front-service housing installed, follow these instructions:
1. Remove the front bezel as follows:
a. See Figure 17 on page 29. Press the left latch and depress the center latch
to loosen the bezel.
b. Press the right latch to release the bezel and pull it forward, lifting the bezel
from the machine.
2. See Figure 21. Press upward on the left latch and use the pull-out handle to
extend the system unit from the housing until it stops.
Note: Be sure to use a cart to support the system unit if it is completely
removed.
3. Open the media access door by removing the two screws.
4. Continue with step 3 on page 34 below.
5. To replace, reverse these steps.
For all other models:
1. Follow the instructions in “Removing the covers” on page 29 to remove the front
bezel and top cover.
Figure 21. Opening units with front-service housing
Updated July 14, 2008
Chapter 2. Removal and replacement procedures 33
To Next Page
Loading...
