Removing the spline
To remove the spline:
1. Follow the instructions in “Removing the covers” on page 29 to remove the front
bezel and top cover.
2. Follow the instructions in “Removing the top plate” on page 32 to remove the
top plate.
3. See Figure 29. Locate the spline and lift it upward from notch (Z in Figure 29)
and then outward from notch (W).
4. To replace the spline, reverse these procedures.
ZZ
W
Figure 29. Removing the spline
Updated July 14, 2008
Chapter 2. Removal and replacement procedures 41
To Next Page
Loading...
