2. Locate the rubber seal (A in Figure 28) on the housing and near the exhaust
fan.
3. Pull to remove.
To reinstall:
1. Align the rubber seal with the holes on the chassis, insuring that each
cone-shaped protrusion has a matching hole.
2. Using a pair of pliers, pull the cone-shaped protrusions through the holes.
Figure 28. Location of alignment pen holes
Updated July 14, 2008
40 SurePOS 700 Series: SurePOS 700-721/741/781, 722/742/782 Hardware Service Guide
To Next Page
Loading...
