Removing the UPS
Note: This procedure applies to the wide machine feature only.
1. Remove the front bezel by referring to Figure 17 on page 29.
2. Unplug and remove all of the power cords and the serial cable, if installed.
3. See Figure 46. Untighten the screw (R) on the UPS lock.
4. Slide the bracket to the right and the lift it out of the expansion housing.
R
R
Figure 46. Power supply housing bracket
Figure 47. Lifting the bracket
Updated July 14, 2008
56 SurePOS 700 Series: SurePOS 700-721/741/781, 722/742/782 Hardware Service Guide
To Next Page
Loading...
