Removing the pull-out handle
Follow these steps to install the pull-out handle:
1. Set the unit on a flat surface.
2. See Figure 17 on page 29 and follow the steps to remove the front bezel.
3. Slide the pull-out handle to the left of the clip and rotate as shown. Slide to the
right to remove.
4. To replace, align the handle to the clip at approximately a 45-degree angle. See
Figure 57.
5. Place the pull-out handle on the clip and slide it to the right for a secure fit.
Removing the cable guide
Follow these instructions to replace the cable guide:
1. Pull the 4800 unit from the front of housing and place on a cart
2. Remove the velcro strap holding the cables.
3. Remove the screw holding the cable guide.
4. Remove the cable guide from the 4800 unit and also remove the cables.
Figure 57. Attaching the pull-out handle
Updated July 14, 2008
66 SurePOS 700 Series: SurePOS 700-721/741/781, 722/742/782 Hardware Service Guide
To Next Page
Loading...
