To replace:
5. Reverse these procedures to reinstall the cable guide.
Removing the cable guide arm assembly
1. Pull the 4800 unit from the front of housing and place on a cart
2. Extend the cable guide assembly arm and open the velcro strips from the cable
guide and the cable guide arm assembly.
3. Remove all cables from the cable arm assembly and place aside.
4. Remove the cable guide arm assembly by squeezing and lifting it from the
bottom peg and then from the top peg.
Figure 58. Removing the cable guide
Updated July 14, 2008
Chapter 2. Removal and replacement procedures 67
To Next Page
Loading...
