Removing the front USB card
1. Follow the instructions in “Removing the covers” on page 29.
2. Follow the instructions in “Removing the top plate” on page 32
3. Follow the instructions in “Removing the hard disk drive” on page 36.
4. Disconnect the cable attached to the USB card.
5. Remove the two screws (A in Figure 52) holding the USB card to the system
unit.
6. Lift card and remove it from the front of the unit.
7. To replace card, reverse these procedures.
A
Figure 52. Removing the front USB card
Updated July 14, 2008
Chapter 2. Removal and replacement procedures 61
To Next Page
Loading...
