3. See Figure 19 and locate the metal holding clip, C, located in the rear center
of the top cover. Push this clip downward and push the cover backward a few
inches before lifting upward to remove.
To replace the top cover:
1. Hold the cover in position over the system unit so that the front is aligned with
the line on the metal top and drop the cover onto the machine. Slide the cover
forward to lock into place.
2. Close the modesty cover by pressing downward on the door. Replace the bezel
by aligning the hooks on the bottom of the bezel with the slots on the frame and
snapping the top into place.
C
Figure 19. Replacing the top cover
Updated July 14, 2008
Chapter 2. Removal and replacement procedures 31
To Next Page
Loading...
