Models 7x1
5. Locate the heat sink latches on each side of the heat sink.
6. Press down to unlock each latch and then lift upward on the heat sink (M) to
remove.
Note: When the heat sink is removed, you can locate the processor (N)
7. See Figure 34. Press down on the processor latch, and move sideways and up
to unlock. Lift out the processor, carefully keeping your fingers on each side of
the module.
8. Go to step 10.
Models 7x2
9. Loosen the four captured screws to remove the heat sink.
All Models
10.
To replace the processor and heat sink, reverse these procedures.
Note: Models 742 and 782 contain a LGA 775 CPU socket. This socket
contains very finely pitched pins. You must take care when servicing the
CPU as any damage to the socket results in a non-functional system
board. Be sure to use the section cup tool provided with the FRU
processor.
M
N
Figure 34. Heat sink and processor
Updated July 14, 2008
46 SurePOS 700 Series: SurePOS 700-721/741/781, 722/742/782 Hardware Service Guide
To Next Page
Loading...
