Model 7x2 only
9. Release the mechanical latch (see E in Figure 43) retaining the riser card as
follows:
a. Tilt the riser toward the latch.
b. With your hand, unhook the latch.
10.
Lift out the riser card.
All Models
11.
To replace the riser card, reverse these procedures.
Note:
When replacing the riser card, ensure that the cash drawer voltage
setting matches the voltage setting on the old riser card. See “Cash
drawers” on page 18 for additional information.
Figure 43. Riser card latch
Updated July 14, 2008
Chapter 2. Removal and replacement procedures 53
To Next Page
Loading...
