4. Locate the latch (A in Figure 50) inside of the power supply housing. Using a
screwdriver, pry the latch upward.
5. Push the power supply housing backward from the unit until it unlatches.
Note: Before you install the expansion housing, be sure that the latch is flush
with the side of the housing, and not bent inward.
6. To install the expansion housing, reverse these procedures.
Note: Be sure the latch (A in Figure 50) is engaged and the expansion
housing bracket is securely fastened.
A
Figure 50. Prying the expansion housing latch upward
Updated July 14, 2008
Chapter 2. Removal and replacement procedures 59
To Next Page
Loading...
