2. Determine which hard disk drive has failed by opening the detected hard drive
(see Figure 64). In the example, the detected hard drive’s Device Port is 1;
therefore, the failed hard drive is located on Device Port 0.
3. Initiate shutdown and power off the machine (Start, Shutdown, press the power
switch, or follow the procedure for your business.)
4. Continue with the steps described in “Replacing and rebuilding a hard drive” on
page 77.
Method two: Entering RAID during start-up
1. Shutdown and reboot the machine (Start, Shutdown, press the power switch,
or follow the procedure for your business.)
Figure 64. Disk drive failure
Updated July 14, 2008
76 SurePOS 700 Series: SurePOS 700-721/741/781, 722/742/782 Hardware Service Guide
To Next Page
Loading...
