IBM AS/400e

AS/400e Dedicated Server for Domino 139
AS/400e Dedicated Server for Domino
amount of CPW consumed will reduce the available capacity to perform Simple Mail
Users (SMU).
– Processor CPW is an approximate value reflecting the maximum amount of
non-Domino workload (10 to 15% of CPU) that can be supported.
– Interactive CPW is an approximate value reflecting the portion of Processor CPW that
can be used for workloads performing interactive-based tasks (5250). AS/400e
Dedicated server for Domino can be effectively managed when there is no Interactive
CPW (Interactive CPW = 0) available for application workloads. Multiple system
operators performing simultaneous interactive tasks is not supported.
• Any job started from a console (green screen) to perform system administration
function is not considered interactive work if it is the
only interactive job running.
• Any system administration job submitted to batch is not considered interactive
work.
• Any use of Operations Navigator (GUI administration functions) is not considered
interactive work.
• AS/400e server 270 Dedicated Server for Domino processors:
– #2422 Dedicated Domino processor: Pulsar Uni Processor
• Includes eight DIMM memory positions (which plug directly onto the backplane)
• Includes embedded base IOP (CCIN 284D)
• Includes Common Service Processor (CCIN 282F)
– #2423 Dedicated Domino processor: Pulsar Uni Processor
• Includes eight DIMM memory positions (which plug directly onto the
processor—direct attach).
An optional priced Main Storage Expansion Card feature #2884 is available that
supports 16 DIMM memory positions. Either direct attach or the memory riser
feature can be used, but not both. Without the #2884, the DIMMs must be paired.
With the #2884, the DIMMs must be in sets of four (quads) of the same capacity.
There is an exception that allows a single pair of DIMMs on a #2884 if these are
the only two DIMMs on the system. If any additional DIMMs are added above the
initial two, the initial two must be paired up to make a quad, and then only DIMM
quads can subsequently be added.
• Includes Base I/O backplane (CCIN 282F)
• Includes embedded base IOP (CCIN 284E)
• Includes Common Service Processor (CCIN 282F)
• Includes internal flex cable for HSL enablement