Select this choice to view or change the processor settings.
– Memory
Select this choice to view or change the memory settings.
– Devices and I/O Ports
Select this choice to view or change assignments for devices and
input/output (I/O) ports. You can configure the remote console redirection,
and enable or disable integrated Ethernet controllers. If you disable a device,
it cannot be configured, and the operating system cannot detect it (disabling a
device is equivalent to disconnecting the device).
You can also choose to enable or disable adapter option ROM support.
Disabling support can potentially improve the time it takes the blade server
to start.
– Power
Select this choice to view or change Active Energy Manager (AEM) power
capping to control power consumption and processor performance states.
– Boot Modes
Select this choice to view or change the power scheme options.
– Operating Modes
Select this choice to determine operational settings, such as operating mode
(acoustic, efficiency, or performance) and memory speed.
– Legacy Support
Select this choice to view or set legacy support.
- Force Legacy Video on Boot
Select this choice to enable or disable force INT video support, if the
operating system does not support UEFI video output standards. The
default is Enable.
- Rehook INT 19h
Select this choice to enable or disable devices from taking control of the
boot process. The default is Disable.
- Legacy Thunk Support
Select this choice to enable or disable UEFI to interact with PCI mass
storage devices that are non-UEFI compliant. The default is Enable.
- Infinite Boot Retry
Select this choice to enable or disable UEFI to infinitely retry the legacy
boot order.
- Non-planar PXE
Select this choice to enable or disable non-planar PXE for legacy mode.
– System Security
Select this choice to view or change the security options for Trusted Platform
Module (TPM).
– Integrated Management Module
Select this choice to view or change the settings for the integrated
management module II (IMM2).
- Commands on USB Interface
Select this choice to specify whether the Ethernet over USB interface is
enabled or disabled.
Chapter 4. Configuring the blade server 49
To Next Page
Loading...
Need help?
General