Note: This option is primarily for older operating systems that have
problems with USB communications device class (CDC) Ethernet interfaces.
Disabling this option will cause the following issues:
v Online update packages will not work.
v Updates that use Bootable Media Creator (BoMC) will not work because
BoMC uses the LAN over USB interface.
v You must install the IPMI device driver to use ASU to change the IMM2
or UEFI configuration.
v You cannot set the IMM2 OS Loader watchdog.
- Network Configuration
Select this choice to view the system management network interface port,
the IMM2 MAC address, the current IMM2 IP address, and host name;
define the static IMM2 IP address, subnet mask, and gateway address;
specify whether to use the static IP address or have DHCP assign the
IMM2 IP address; save the network changes; and reset the IMM2.
- Restore IMM to Defaults
Select this choice to restore the IMM2 to the default settings. The IMM2
controller restarts after you restore the settings.
- Reset IMM
Select this choice to restart the IMM2 controller.
– Recovery
Select this choice to view or change recovery settings.
– Storage
Select this choice to view or change the storage device settings.
– Network
Select this choice to view or change the network device options, such as
iSCSI.
– Driver Health
Select this choice to view the status of the controllers installed in the blade
server.
v Date and Time
Select this choice to set the date and time in the server, in 24-hour format
(hour:minute:second).
This choice is on the full UEFI Setup Utility menu only.
v Start Options
Select this choice to view or change the start options, including the startup
sequence, keyboard NumLock state, PXE boot option, and PCI device boot
priority. Changes in the startup options take effect when you start the server.
The startup sequence specifies the order in which the server checks devices to
find a boot record. The server starts from the first boot record that it finds. If the
server has Wake on LAN hardware and software and the operating system
supports Wake on LAN functions, you can specify a startup sequence for the
Wake on LAN functions. For example, you can define a startup sequence that
checks for a disc in the CD-RW/DVD drive, then checks the hard disk drive,
and then checks a network adapter.
This choice is on the full UEFI Setup Utility menu only.
v Boot Manager
Select this choice to view, add, delete, or change the device boot priority, boot
from a file, select a one-time boot, or reset the boot order to the default setting.
50 BladeCenter HS23 Types 7875 and 1929: Installation and User's Guide
To Next Page
Loading...
Need help?
General