49. SAS cable correctly inserted into the SAS port ....................................................................................... 61
50. SAS cable connector orientation.............................................................................................................. 62
51. Features on the front of the Model 092 expansion enclosure.................................................................62
52. Secure power cables ................................................................................................................................63
53. Power and SAS cable connections on the back of the enclosure ...........................................................64
54. Features on the rear of the Model 092 expansion enclosure..................................................................64
55. LEDs on the front of the expansion enclosure......................................................................................... 66
56. LEDs on the front of a power supply unit................................................................................................. 67
57. LEDs on a drive assembly ........................................................................................................................ 67
58. LEDs on a secondary expansion module..................................................................................................68
59. LEDs on the back of the expansion enclosure......................................................................................... 69
60. LEDs on the back of the expansion canister............................................................................................ 69
vii
To Next Page
Loading...
