IBM SurePOS 500 User Manual

SurePOS 500 4846-XX5 Technical Reference
Page 48 of 63
Prevents messages prompting the user to touch the screen to enter CMOS Setup, unless an error occurs.
Default: Disabled
Options:
• Disabled
• Enabled
No Setup Touch Entry
If enabled, prevents entering CMOS Setup using the touch screen. A keyboard can still be used to enter CMOS
Setup.
Default: Disabled
Options:
• Disabled
• Enabled
Boot Up NumLock Status
Selects the power-on state for the keyboard NumLock. Select “Off” when using a keyboard in DOS that shares the
numpad keys with letter keys.
Default: On
Options:
• Off
• On
Security Option
Select whether the password is required every time the system boots or only when entering CMOS Setup.
Select “Setup” to require a password before entering the CMOS Setup Utility. Select “System” to require a password
before entering CMOS setup or before booting from one of the selected boot devices.
Use the “Set Password” option on the main menu to set the password. If the password is blank, this option has no
affect.
Default: Setup
Options:
• Setup
• System
APIC Mode
This item is for information only and cannot be configured. It shows whether the Advanced Programmable Interrupt
Controller is enabled. Some operating systems will utilize the APIC.
HDD S.M.A.R.T. Capability
Select "Enabled" to allow detecting and reporting of some hard disk errors during the POST (Power On Self Test).
The BIOS does not detect errors; it only shows errors detected and reported by the hard disk.
Default: Enabled
Options:
• Disabled
• Enabled

IBM SurePOS 500 Specifications

General

Brand	IBM
Model	SurePOS 500
Category	Touch terminals
Language	English