Using the IBM ServeRAID Configuration Utility program
Use the IBM ServeRAID Configuration Utility to perform the following tasks:
v Configure a redundant array of independent disks (RAID) array
v View or change the RAID configuration and associated devices
For
additional information about how to use the IBM ServeRAID Configuration
Utility, see the documentation on the IBM ServeRAID Support CD.
IBM ServeRAID Configuration Utility menu choices: The following choices are
on the IBM ServeRAID Configuration Utility menu:
v Array Configuration Utility
Select this choice to create, manage, or delete arrays, add or delete a hot-spare
drive, or initialize drives.
v SerialSelect Utility
Select this choice to configure the controller interface definitions or to configure
the physical transfer and SAS or SATA address of the selected drive.
v Disk Utilities
Select this choice to format a disk or verify the disk media. Select a device from
the list and read the instructions on the screen carefully before making a
selection.
Starting
IBM ServeRAID Configuration Utility program: To start the IBM
ServeRAID Configuration Utility program, complete the following steps:
1. Turn on the server.
2. When the message Press <CTRL><A> for IBM ServeRAID Configuration
Utility appears, press Ctrl+A. If you have set an administrative password, you
are prompted to type the password.
3. To select a choice from the menu, use the arrow keys to highlight it and press
Enter.
Creating a RAID array
To use the IBM ServeRAID Configuration Utility to configure a RAID level-1 array,
complete the following steps:
1. From the IBM ServeRAID Configuration Utility program menu, select Array
Configuration Utility.
2. Select Create Array.
3. From the list of ready drives, select the two drives that you want to group into
the array.
4. When you are prompted to select the RAID type, select RAID 0 or RAID-1.
5. (Optional) Type an identifier for the array.
6. When you are prompted for the array build method, select Quick Init.
7. Follow the instructions on the screen to complete the configuration; then, select
Done to exit.
8. Restart the server.
Viewing the array configuration
To view information about the RAID array, complete the following steps:
1. Start the IBM ServeRAID Configuration Utility program.
2. From the IBM ServeRAID Configuration Utility window, select Manage Arrays.
3. Select an array and press Enter.
48 System x3400 Types 7973, 7974, 7975, and 7976: Installation Guide
To Next Page
Loading...
