The following illustrations show the supported combination of drive backplane
configurations that you can use to support 16 drives:
This configuration consists of four 4x2.5-inch drive backplanes and requires
four SAS signal cables.
This configuration consists of one 8x2.5-inch drive backplane and two
4x2.5-inch drive backplanes and requires four SAS signal cables.
This configuration consists of two 4x2.5-inch drive backplanes and one
8x2.5-inch drive backplane and requires four SAS signal cables.
This configuration consists of two 8x2.5-inch drive backplanes and requires four
SAS signal cables.
This configuration consists of two 4x2.5-inch drive backplanes and one
8x1.8-inch drive backplane and requires four SAS signal cables.
16 1918
0123
Empty
4567
17 20 21
2.5” HDD/SSD
2.5” HDD/SSD
2.5” HDD/SSD
2.5” HDD/SSD
2.5” HDD/SSD
2.5” HDD/SSD
2.5” HDD/SSD
2.5” HDD/SSD
1.8” SSD
1.8” SSD
1.8” SSD
1.8” SSD
1.8” SSD
1.8” SSD
1.8” SSD
1.8” SSD
22 23
This configuration consists of one 8x2.5-inch drive backplane and one
8x1.8-inch drive backplane and requires four SAS signal cables.
Chapter 2. Installing optional devices 65
To Next Page
Loading...
