SAS signal cable
SAS signal
cable guide
Adapter
Cable ties
Scalability
connector
cover
Cable tie
loops
Microprocessor
air baffle
12. Connect the other SAS signal cables to port 1 on the ServeRAID expansion
adapter to port 0 on the drive backplane; then port 2 on the expansion
adapter to port 1 on the drive backplane, port 3 on the expansion adapter to
port 2 the drive backplane, and port 4 on the expansion adapter to port 3 on
the drive backplane (depending on the drive backplane you install in the
server).
If you have other devices to install or remove, do so now. Otherwise, go to
“Completing the installation” on page 112.
84 System x3690 X5 Types 7147, 7148, 7149, and 7192: Installation and User's Guide
To Next Page
Loading...
